:00Thu 24 Sep
Later · not in R1Neo 0032 §24; PRD §1.4
Stencil racks: stencils stored by slot, their tower, and taking a stencil out to a printer
- Not in R1
- Neo keeps the model shape for stencils but defers their qualification and journeys until after R1: release 1 stores reels only
- R1 instead
- Reel racks only. Stencils stay where the site keeps them today, outside Janus Open Equipment
ST-01 · Stencil tower
Technical details
- Shape
- 4 tiers × 12 slots
- Controller
- CTRL-S01
- Address
- 192.168.0.24
- Floor label
- POS-ST-01
No job on ST-01
What you can do without a permit
You can identify the rack, read its sensors and try to reconnect it. Anything else needs a permit from the person who owns it.
Wiring map
CTRL-S01HF-XGate2-P4192.168.0.24
- Firmware
- V2.01-2503 · reported 06:02
- Built
- 4 tiers × 12 · 4 bay boards + tower board 5
- Towers
- Top · on board 5
- Bus 1
- No answer since 07:12
Check a slot on tier 4: Board 4T4
Check a slot on tier 3: Board 3T3
Check a slot on tier 2: Board 2T2
Check a slot on tier 1: Board 1T1
Board 5
Tower light
- No answer · controller offline
- Unknown
Can’t compare
CTRL-S01 is offline since 07:12
The wiring can be compared once it answers. Wiring version 1 stays in use.
Tiers, boards and towers
| Tier | Sensor boards | Light boards | Slots | State | Last checked |
|---|---|---|---|---|---|
| T4 | Bus 1 · 4 | Bus 1 · 4 | 12 | No answer | 07:10 · before it went offline |
| T3 | Bus 1 · 3 | Bus 1 · 3 | 12 | No answer | 07:10 · before it went offline |
| T2 | Bus 1 · 2 | Bus 1 · 2 | 12 | No answer | 07:10 · before it went offline |
| T1 | Bus 1 · 1 | Bus 1 · 1 | 12 | No answer | 07:10 · before it went offline |
| Tower light | — | Bus 1 · 5 out 1 | — | No answer | 07:10 |
Wiring history
- 07:12Controller offline · last compared 07:10, no differencesJanus
- Fri 12 SepVersion 1 turned on · rack added to serviceDávid Horváth · Rack setup